dnafere.blogg.se

1. #What does toyota tis techstream cost to use install#
2. #What does toyota tis techstream cost to use update#

These settings point Techstream to the correct location of the XHorse driver used for the MVCI Cable.Īlso do not forget the TISFUNCTION=0 modification in the IT3System.ini file. You can also manually point the original Techstream interface entries in the registry (same location) to the same Xhorse files just to be sure.

#What does toyota tis techstream cost to use install#

Then install Techstream and apply the registry fixes (either manually or by the downloadable registry mod file), also previously mentioned. If this is OK then at least your interface should be installed correctly, showing a red LED in the process.

Just do NOT update, only use it to see if the cable is recognized and reports back its firmware version + “connected” status.

#What does toyota tis techstream cost to use update#

When installed correctly you should be able to run the firmware update tool to check the firmware. You can actually check all stages of the installation without connecting to the car:įirst make sure to follow the unpacking/copying instructions in the 64-bit installation instructions before plugging in the cable in the USB port. Installed it using the 64bit for Windows 7/8 instructions previously mentioned and on Using Techstream 12.30.017 (newest: v14.20.019) with the cheap Mini VCI Cable J25345 over here (Firmware 1.4.1) on a HP-Zbook with Windows 10-64bits prof. Best I can tell the only XHorse interface firmware version that I used that worked with it is mini vci cable 2.0.4, these are cloned versions of Techstream and the XHorse cable interface, the real Toyota Techstream costs nearly $2000.